Embedded Products
EMBEDDED SYSTEMS LAB EXPERIMENT KIT

PROCESSOR MODULES:
Freescale, NXP, TI and ATMEL

PERIPHERALS:
I2C module
Infrared module
Universal Serial Bus(USB)Module
CAN module
RF module
Bluetooth module
Graphic LCD module
Zigbee module
Temperature sensor module
Accelerometer module
Pressure sensor module
Ethernet Module
MICROCONTROLLER MODULES
Freescale
Features

MC9S12E128, Package:112 LQFP
16 Bit HCS 12 CORE,HCS 12 CPU | 32K,64K,128K Flash EEPROM | 2Kb,4Kb,8Kb RAM | Operating Freq:50 MHz Equivalent to 25MHz Bus Speed | One I2C Communication port | One SPI Communication port | One On board Infrared Transmitter | Two channel DAC, 8 Bit Resolution

TI
Features

MSP430F6635 Package:100PZ 113 ZQW 256K Flash, 16+2 SRAM | Four 16 Bit Timer with 3,5 or 7 Capture Registers | Two Universal Serial Communication Interfaces | Full Speed USB | 12 Bit A/D Converter | Dual 12 Bit D/A Converters | Two IrDA | Two SPI | Two UART | Two I2C

NXP
Features
LPC 2129 and 2148 Package: 64LQFP | Core Processor ARM 7 | Core Size 16/32 bit | Speed 60Mhz | Flash:256 K | RAM:128K | Connectivity: CAN, I2C, SPI,UART,SSI,SSP | A/D:4x10b

ATMEL
Features

ATXMEGA 128B1 Package:100TQFP | Core Size 8/16 bit | Speed:32 MHz | Flash:128K | RAM:8Kx8 | Connectivity:I2C, IrDA,SPI,UART,USART,USB

PERIPHERALS

Universal Serial Bus (USB)
Features

Configure as Full speed and Low speed Host controller | Configure as Full speed and Low speed Device | USB1.1 and USB2.0 compliant full-speed/low-speed device Controller | 16 bi-directional end points | DMA or FIFO Data stream interfaces | Low-power consumption | Power On LED indication | Serial Interface (SCI)

CAN module
Features
Hardware feature Same as Processor Board as mentioned in section 1 | Implementation of CAN-version 2.0 A/B as defined in BOSCH Specifications. | Standard Data frame support | Zero to Eight byte of Data length support. | Eleven bits of Identifier in Message. | CAN Bus speed up-to 125kBps | Provisions to connect up to 32 CAN nodes. | Programmable initialization mode, Listen-only mode and Loop back mode

RF module
Features
Line Of Sight range, Open Ground is up to 50 meters with Whip Antenna | 433MHz of operating Carrier frequency. | Data rate of 300Bps to 10kBps | Working voltage of 3 - 12V and 2.4 - 3 mA of supply current | Receiver sensitivity -104dBm to -102dBm | Serial Communication Interface for Data transmit and Receive | ASK modulated RF communication

Zigbee module
Features
Range - Up to 100 m with 2 db antennas | Outdoor RF Line-of-sight Range Up to 1 km with appropriate high gain antennas and elevation | Transmit Power: up to 1 watt / 30 dBm nominal. | Receiver Sensitivity: up to –92 dBm. | RF data rate: 250 kbps. | Operating Frequency ISM 2.4 GHz | AT Command Modes for configuring Module Parameters | Direct sequence spread spectrum technology. | Analog to digital conversion and digital I/O line support

Temperature sensor module
Features
LM35 temperature Sensor | Calibrated directly in °C (Centigrade) | Linear 10mv/°C scale factor | 0.5°C accuracy guarantee at 25°C | Rated for full −55° to +150°C range | One potentiometer is to simulate the temperature | Switch to select between temperature sensor and potentiometer output. | Power On LED indication | Low self-heating, 0.08°C in the still air.

Accelerometer module
Features
ADXL335 Accelerometer sensor | High Sensitivity (800 mV/g @ 1.5g) | Selectable Sensitivity (±1.5g, ±6g) | Fast Turn on Time (0.5 ms Enable Response Time) | Self Test for Freefall Detect Diagnosis | 0g-Detect for Freefall Protection | Signal Conditioning with Low Pass Filter | Low Cost | Sensitivity 800mV/g at 1.5g or 206,V/g at 6g | Power On/Off switch

Bluetooth module
Features
Class 1 Bluetooth Transmission and V2.0 Bluetooth Qualification | Range up to 250 meters typical in free space | Operating Frequency ISM 2.4 – 2.485 GHz | Transmission Power -27dBm to +6dBm | Receiver sensitivity -86dBm | Data transfer rate up to 300kBps over UART | AT command mode for Configuration and Communication | Support for RTS and RESET signals in Serial Interfacing | Point to point and Point to multipoint communication support |

Graphic LCD module
Features
LCD type:STN | LCD duty:1/16 | LCD bias:1/5 | Viewing direction:6 / 12 o’clock | Viewing area(W x H):85x19.8mm | Number of Dots:128 x 64 | Character matrix (W x H):5 x 8 dots | Character size (W x H):3.20 x 5.55 mm | Dot size (W x H):0.60 x 0.65 mm | Dot pitch (W x H):0.65 x 0.70 mm

Pressure sensor module
Features
Spx100d | Differential output | Operating pressure range 0 to 100kPa. | <0.1% full scale combined linearity and Hysteresis Error | Burst pressure is 3 times operating pressure | Operates on 3.3V | Operating temperature -40 to +125°C | 4 Pin Package | Signal conditioner is required to convert the differential output to single line output | Power On LED indicator

Ethernet module
Features
Support for two different Ethernet physical interfaces: | 100-Mbps IEEE 802.3 MII | 10-Mbps IEEE 802.3 MII | IEEE 802.3 full duplex flow control | Programmable max frame length supports IEEE 802.1 VLAN tags and priority | Support for full-duplex operation (200 Mbps throughput) with a minimum internal bus clock rate of 50 MHz | Support for half-duplex operation (100 Mbps throughput) with a minimum internal bus clock rate of 50 MHz | Retransmission from transmit FIFO following a collision (no processor bus utilization) | Address recognition | Frames with broadcast address may be always accepted or always rejected | Exact match for single 48-bit individual (unicast) addr | Promiscuous mode
© Copyright ©2012 Matrix Semiconductors and Telecommunications Pvt. Ltd. All Rights Reserved Designed by : webKrft.com